|
|
发表于 2018-7-14 21:31:17
|
显示全部楼层
这个固件支持以下CPU吗？
MediaTek SoC: MT7620N, RevID: 0203, RAM: DDR1, XTAL: 20MHz
CPU/OCP/SYS frequency: 580/193/193 MHz
CPU revision is: 00019650 (MIPS 24KEc)
Determined physical RAM map:
memory: 04000000 @ 00000000 (usable)
Zone PFN ranges:
Normal 0x00000000 -> 0x00004000
Movable zone start PFN for each node
Early memory PFN ranges
0: 0x00000000 -> 0x00004000
Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
Built 1 zonelists in Zone order, mobility grouping off. Total pages: 16256
Kernel command line: console=ttyS0,57600n8 root=/dev/mtdblock4 rootfstype=squashfs
PID hash table entries: 256 (order: -2, 1024 bytes)
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Writing ErrCtl register=000540c3
Readback ErrCtl register=000540c3
Memory: 61276k/65536k available (2833k kernel code, 4260k reserved, 528k data, 220k init, 0k highmem)
NR_IRQS:40
console [ttyS0] enabled
Calibrating delay loop... 385.02 BogoMIPS (lpj=770048)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
NET: Registered protocol family 16
bio: create slab <bio-0> at 0
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
Switching to clocksource MIPS
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP: reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
squashfs: version 4.0 (2009/01/31) Phillip Lougher
msgmni has been set to 119
io scheduler noop registered
io scheduler bfq registered (default)
BFQ I/O-scheduler version: v7r7
Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0x10000c00 (irq = 12) is a 16550A
Ralink GPIO driver initialized. Number of GPIO: 73, GPIO mode: 005A171D
loop: module loaded
Ralink SPI flash driver, SPI clock: 24MHz
SPI flash chip: W25Q128FV (ef 40180000) (16384 Kbytes)
Creating 7 MTD partitions on "raspi":
0x000000000000-0x000000030000 : "Bootloader"
0x000000030000-0x000000040000 : "Config"
0x000000040000-0x000000050000 : "Factory"
0x000000050000-0x0000001844b0 : "Kernel"
0x0000001844b0-0x000000fc0000 : "RootFS"
0x000000fc0000-0x000001000000 : "Storage"
0x000000050000-0x000000fc0000 : "Firmware_Stub" |
|
[复制链接]
